Before and after calibrating, MY RGB settings are the same, 100/100/100. Next there is an absolute lack of RGB calibrating. One that gets a good screen-to-print match for you. While getting in the neighborhood of the green zone is a good starting point, you're likely going to end up using a different number in the end. The green point is more trouble than it's worth different situations yield different luminance requirements. Playing with luminance, setting the brightness setting I had trouble hitting the "green point". It shouldn't be adjusted under normal circumstances. Your "contrast" OSD adjustment just munges the incoming signal to flub some facsimile of contrast control. You can't adjust contrast on an TFT LCD it's a function of the backlight brightness and the design of the panel. I noticed through playing with luminance, that the Colormunki basically ignores the contrast setting.Ĭorrect. If native looks better, try working with native. D65 will look warm to most users, as it's still fairly common for consumer-level displays to ship configured for an extremely blue ("white") picture. Similarly, unless they're the same grey, you're just grasping at straws. Unless your lighting is D65, that tells you nothing about the quality of the monitor profile. I will call Xrite tommorow, but have a feeling they will tell me absolutely nothing in which case I will return this piece of equipment.Ĭomparing a neutral grey on screen to one on paper (color chip from XRite) the grey looks very warm and no where near neutral. I am just really disappointed because I could have spent these 4 hours calibrating my monitor by hand to get much better results, and save a lot of money too. I would bet the RGB settings have some role in making the colors on my screen appear warm - the yellows are oversaturated and the reds are as well (slightly less). Nothing changes, no options in the software to calibrate the RBG settings, nothing. I paid for this thing I don't want to spend hours guessing what my contrast/brightness should be. I am suprised there is no optimal setting for contrast for this calibrating device. So my next puzzling question is, if there is no set control of the contrast how does this device calibrate anything let alone my monitor? There are literally thousands of possible working contrast-brightness settings I could set my monitor to and each time I will get different colors/results/etc. At this point I can go back to contrast, and upping or lowering the contrast will affect the brightness. I can set it at 0 or at 100, and after calibration it will stay at whatever I set it to. I noticed through playing with luminance, that the Colormunki basically ignores the contrast setting. Comparing a neutral grey on screen to one on paper (color chip from XRite) the grey looks very warm and no where near neutral. Using Native white point I get more natural albeit warm colors. So first I noticed is the with the white point set to D65 I got a blue-purple haze that just did not look right. I've calibrated monitors before, not an expert by any means. I've spent roughly 4 hours trying to calibrate the monitor using "Colormunki Photo". Somehow my post didn't go through so quickly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |